S015 Cleaning Guidelines

To keep your floors slip-resistant it is essential that they are cleaned thoroughly, observing the following:
Clean your floor with the recommended Slipstop liquid cleaner, while adhering to your tile manufacturer’s guidelines. Never use a cleaner that leaves a film on the floor.

When using S 015 dilute with up to 40 parts of warm water dependent upon severity of the task.
It is recommended to give the floor a thorough scrub with a deck brush or a scrubbing machine at least once a month.


If you use a mechanical scrubber, use only with a brush attachment. DO NOTUSE AN ABRASIVE PAD.
DO NOT USE A POWDERED DETERGENT as it leaves calcite film on the surface.
DO NOT POLISH OR SEAL SLIPSTOP TREATED FLOORS as this will negate the treatment.

When these guidelines are followed, the floor is guaranteed to stay slip-resistant for a minimum of five years (safe classification measured with a TRACSCAN 2.0friction tester).
In cases where the above guidelines are ignored, you will experience a decline inslip resistance through a buildup of contamination on the floor. This can berestored by deep cleaning the floor with Slipstop “Wax and Grease Remover – S085”, followed by a thorough scrubbing with Slipstop “Safe Cleaner Solution – S055”.


For further advice or information please do not hesitate to get in touch.

Document ID:
#149
Date & Time:
2 months
Category:
Test Doc1

The Job Spec.

Download

Deck:

Area:

Square metres:

Material:

Friction test results before:

Friction Test Results After:

Pictures/friction test results :

Deck:

Area:

Square metres:

Material:

Friction test results before:

Friction Test Results After:

Pictures/friction test results :

Deck:

Area:

Square metres:

Material:

Friction test results before:

Friction Test Results After:

Pictures/friction test results :

Deck:

Area:

Square metres:

Material:

Friction test results before:

Friction Test Results After:

Pictures/friction test results :